ubnt

networking/ubiquiti-edgeswitch.md

@@ -0,0 +1,47 @@
+---
+title: Ubiquiti EdgeSwitch
+breadcrumbs:
+- title: Server
+---
+{% include header.md %}
+
+## General
+
+- Default credentials: Username `ubnt`, password `ubnt`.
+- Serial settings: Baud 115200, 8 data bits, 0 parity bits, 1 stop bit, no flow control.
+
+## Initial Setup
+
+Tested with an EdgeSwitch 16 XG.
+
+1. Basics (use where appropriate):
+    1. Log in: Username `ubnt`, password `ubnt`.
+    1. Enter enable mode: `en`
+    1. Enter config mode: `conf`
+    1. Exit any mode: `exit`
+    1. Save config: `write mem`
+1. Setup enable-mode stuff:
+    1. Set hostname: `hostname <hostname>`
+    1. **TODO** Network stuff?
+    1. Setup VLANs:
+        1. Enter VLAN mode: `vlan database`
+        1. **TODO**
+1. Setup basics:
+    1. Set pre-login banner: `set clibanner "Hello"`
+1. Setup AAA:
+    1. **TODO**
+1. **TODO**:
+    1. IGMP/MLD snooping.
+
+## Tasks
+
+### Reset
+
+1. Wait until fully booted.
+1. Press and hold the reset button for 30 seconds (exact duration is unclear). Holding it for a too short duration will simply reboot the device instead.
+
+### Upgrade Software
+
+**TODO**
+
+{% include footer.md %}