|
|
@@ -17,12 +17,14 @@ breadcrumbs:
|
|
|
- DCA groups: Doesn't carry audio but instead remote controls the level of a set of inputs.
|
|
|
- Tap points:
|
|
|
- Tap points are used for both mixbuses (typically pre-fader) and outputs (typically post-fader).
|
|
|
+ - Tap points are wrt. each input channel-output bus-pair, but each two mixbuses must share the tap point (even when not linked).
|
|
|
- The "+M" tap variant mutes the tap too when the channel/bus is muted.
|
|
|
- In/LC (1): After preamp gain and low cut.
|
|
|
- Pre-EQ (2): Before EQ.
|
|
|
- Post-EQ (3): After EQ, before compressor if using post-EQ compressor.
|
|
|
- Pre-fader (4): Before fader.
|
|
|
- Post-fader (5): After fader.
|
|
|
+ - Sub group (6): After fader, with no level control for channel send.
|
|
|
- The sampling rate (44.1k or 48k) must be set equally for everything connected, including AES50, USB and USB recordings.
|
|
|
- Use the "L/R + Mono" panning mode, where you manually assign sources to LR and/or mono outputs and pan only applies to LR. If you have a center speaker/cluster, this allows you to assign vocals/talks to only the center to avoid combing filter effects and such which might be especially noticable for certain audio types. The "LCR" mode sets left, center, right side-by-side panning-wise, so that the source is only sent to the center when the pan knob is centered. LCR mode may appropriate for more "immersive" sound images.
|
|
|
- Use "M/C depends on Main L/R" if you want the mono level to follow (depend on) the LR level.
|
|
|
@@ -90,10 +92,6 @@ breadcrumbs:
|
|
|
- Three sets can be configured (A, B and C).
|
|
|
- The X32 Compact doesn't have the strip displays, four knobs or the three buttons to select sets. Switching sets can be done via the view display instead.
|
|
|
|
|
|
-## Presets
|
|
|
-
|
|
|
-- **TODO**
|
|
|
-
|
|
|
## Remote Control
|
|
|
|
|
|
- For Windows/MacOS/Linux, use X32Edit (Arch Linux: `yay/x32edit`).
|
HON95