HON95-wiki/networking/security.md

---

title: Network Security breadcrumbs:

• title: Network --- {% include header.md %}

TODO: Distribute this into relevant pages. Maybe the theory section.

Hosts

• Smurf and Fraggle attacks:
  • DDoS where the adversary uses sends an ICMP/UDP echo packet (or similar) to a broadcast/multicast address using a spoofed source address, causing all reply traffic to be sent toward the user of the spoofed address.
  • Linux hosts:
    • Ignore broadcast/multicast ICMP echo and timestamp: net.ipv4.icmp_echo_ignore_broadcasts=1 (Ignored (1) by default)
    • Ignore UDP echo etc.: Firewall it.
• ICMP redirects (IPv4):
  • Should be blocked or ignored for IPv4 since they can act as attack vectors and are basically never used in network designs.
  • Allows attackers to change the default gateway or inject bogus routes.
  • For IPv6, it is a more central functionality and should not be disabled.
  • Can be blocked by the firewall or ignored through configuration.
  • Linux:
    • Linux has a secure variant (secure_redirects) that specifies that the host will only accept redirects from hosts in its gateway list.
    • Disable reception of "insecure" ICMP redirects: net.ipv4.conf.<all+default>.accept_redirects=0 (enabled (1) for hosts and disabled (0) for routers by default)
    • Disable reception of secure ICMP redirectsnet.ipv4.conf.<all+default>.secure_redirects=0 (enabled (1) by default)
    • Disable sending ICMP redirects: net.ipv4.conf.<all+default>.send_redirects=0 (enabled (1) by default)
• SYN cookies:
  • Should be enabled on servers.
  • Prevents TCP DDoS attacks.
  • When the connection queue is filled up, SYN cookies are used for new connections. Connections using SYN cookies must have all TCP options rejected, thus violating TCP.
  • Linux:
    • Enable: net.ipv4.tcp_syncookies=1 (enabled (1) by default)

Switches

TODO (see switch pages, personal notes and papers on my desk)

Routers

• ICMP redirects:
  • See the Hosts section.
• Source routing:
  • Should generally be disabled unless required. May be used in certain mobility scenarios.
  • Allows attackers to send packets to unintended paths/destinations.
  • For IPv4, there is the Strict Source Route (SSR) option and the Loose Source Routing (LSR) option. Both are considered insecure.
  • For IPv6, there is the type 0 routing header, type 2 routing header and type 4 Segment Routing Header.
  • Linux:
    • Enabled by default on routers.
    • Disable IPv4 SSR and LSR: net.ipv4.conf.<all+default>.accept_source_route=0 (disabled (0) for hosts and enabled (1) for routers by default)
    • Disable IPv6 type 0 routing headers only: net.ipv6.conf.all.accept_source_route=0 (type 2 only allowed (0) by default)
      • (Optional) Disable both IPv6 type 0 and 2 routing headers: net.ipv6.conf.all.accept_source_route=-1
  • Cisco IOS:
    • Disable source routing: no source-route (enabled by default)
• Source verification:
  • Should be handled somehow if possible.
  • May prevent spoofed IP addresses, especially
  • Can be done with firewall rules, reverse path forwarding (RPF), DHCP snooping-based verification, etc. based on scenario.
• Reverse path filtering (RPF):
  • Should be enabled for downlinks, but probably not for uplinks and transit links. For the latter two, use ACLs/firewall rules instead. Be especially careful for links with a default route pointing to it.
  • Use strict mode most of the cases, but loose mode if assymmetrical routing may happen.
  • Filters packets from sources that are not reachable by the FIB (loose mode); or filter packets from sources that are not received on the interface that would be used to reach the source (strict mode).
  • Linux:
    • Enable for IPv4 globally or per interface: net.ipv4.conf.all.rp_filter=<0|1|2>
    • Status for IPv6: Unknown.
    • Disabled (0), strict (1) or loose (2).
  • Cisco IOS:
    • Enable per interface: <ip|ipv6> verify unicast source reachable-via <any|rx>
    • Loose ("any") or strict ("rx").
  • VyOS (global):
    • Enable globally: firewall source-validation strict
    • TODO: Status for IPv6.
• Directed broadcast forwarding:
  • Should be disabled.
  • Exploited by e.g. smurf and fraggle attacks.
  • Linux routers:
    • Always disabled.
  • Cisco IOS:
    • Disable no ip directed-broadcast (disabled by default)
• Bogin filtering:
  • Should be enabled if appropriate.
  • Blocks packets from fake/invalid addresses such as from unused or unallocated prefixes.
  • May include RFC 1918 addresses.
  • Can be done by explicitly blacklisting all stable bogon prefixes.

L4 Firewalls

• NAT traversal protocols:
  • E.g. Universal Plug and Play (UPnP), NAT Port Mapping Protocol (NAT-PMP), Port Control Protocol (PCP), Session Traversal Utilities for NAT (STUN).
  • Should generally be turned off unless explicitly needed. It's typically used by multiplayer games and other peer-to-peer applications.
  • Can function as attack vectors as an adversarial program may be able to exploit it to allow external connections to internal devices.

L7 Firewalls

Empty.

Intrusion Detection Systems (IDSes)

Empty.

{% include footer.md %}