basics.md 2.1 KB
title: Audio Basics breadcrumbs:
- title: Audio & Video
title: Audio
{% include header.md %}
Bands:
- Lows (ca. 20Hz-100Hz)
- Low midrange (ca. 100Hz-1kHz)
- High midrange (ca. 1kHz-10kHz)
- Highs (ca. 10kHz-20kHz)
Signal levels:
- +4dBu: Professional equipment.
- -10dBV: Consumer equipment. Lower than +4dBu. Not to be confused with dBv.
- Phono: Old, for turntables etc. Much lower voltage than line level. Typically needs a phono preamp/stage with RIAA equalization.
- Not to be confused with SPL dB.
Balance mode:
- Unbalanced: Ground and signal.
- Balanced: Ground and hot and cold signal with equal impedance. The cold signal is 0V but not (directly) connected to ground.
- Differential: Balanced but the cold signal is the opposite voltage of the hot signal instead of 0V.
- Balanced and unbalanced mono plugs/sockets can generally be connected together (with the loss of the balanced signal), but don't connect e.g. a stereo unbalanced TRS to a mono balanced TRS. It'll sound weird.
Ground loops:
- When there exists physical loop in the ground wires. Typically when devices are connected to different grounded power outlets.
- Different potentials in the loop will cause undesired current flow.
- Can be heard as a 50Hz/60Hz hum in the audio signal.
- Solutions:
- Use balanced signals.
- Connect all equipment to a single grounding point, i.e. a single power outlet.
- Break the shielding on one cable to break the loop. Different boxes, like DI units, may have this as a feature known as a ground lift. However, make sure all shields are connected at one end. Don't break the shielding/earthing on devices that needs it for safety reasons!
- Use a ground loop isolation transformer.
- Group the ground cables together so no currents get induced into the cables.
- Use a resistor and/or a ferrite bead to limit AC current.
Phantom power:
- Applies 48V to XLR3 (or similar) mic inputs. Applying this to devices which aren't made for it can break them.
Impedance:
- Basically resistance but for AC.
{% include footer.md %}